At a point where my hair is falling out with this, I am trying to remove the cell padding but seem to be going around in circles getting no where for days.

1. I created a normal table all good but it had padding i needed removed

2. so went to Predefined XSL Transformation and copied the normal table , reset the cell padding from 4 to 0 which was good, loaded it up but had then no page option at the bottom ( but the padding was OK

3. in Predefined XSL Transformation gain and readng that only the advanced table supported paging i set and copied this, reset the cell padding to 0 as before and loaded this file, all is god except now i have the additional options ( manifying glass on the side that i can not clear, so this option although paging is present is no good

4. Go to User Defined XSL Transformation and generate a new xsl table and generate it with the required page editor etc as needed but in edit mode there is now option to correct the cell padding as it does not exist ( stumped again ) I am guessing this new table is reading from a pre defined template ? But where is it found / named and where do i edit the cell padding in that file ( if that is what happening ?

If any one could help resolve this i would appreciate it

Thanks
Pete

Thanks, i have read , re read the guide over and over, tried what seems to be 100 combination just to remove the 4 pxl padding with a pages option now for days, i will re read it all again to see if i can de bug it , or are saying this just cant be done ?

Edit: i have just re read the guide and i can still not find any reference to adjusting the padding or reference to it ? fast learner and happy to sort it my self if anyone can just point me to the correct area where i can find some help / guide , thanks